Monster Turbine High Performance In-Ear Speakers - Manual (Page 7)

11 12
ENGLISH ENGLISH
2. Use warm water and mild soap on a damp cloth to remove dirt and earwax
from the eartip. Do NoT use harsh cleaning agents.
3. Rinse and completely dry your eartips before placing them back
on your Turbine.
4. Carefully push the eartips back onto the Turbine, making sure they
are on the eartube completely
Using The Cable Management Clip
The Cable Management Clip is designed to control the cable and keep it out of your
way, reduce accidental pulling of the in-ear speakers from your ears, and keep the
cable weight off the in-ear speakers so they stay snug and in place in your ears.
1. Put Turbine In-Ear Speaker
™
into your ears, as you usually
would when listening.
2. Fasten the Cable Management Clip onto your shirt around
the chest or collar area, wherever is most convenient
for the shirt you’re wearing.
3. Grab the cable above the Cable Management Clip
and pull it slightly upward, sliding it through the clip
to create enough slack between the in-ear speakers
and clip to allow for head movement and to take the stress
off the in-ear speakers.
Using The Cable Slider
For further cable management, Turbine
®
comes
with a Cable Slider. The Cable Slider is designed
to reduce tangles during storage, as well as work
in tandem with the Cable Management Clip to eliminate
sway and bounce while in use.
During use, push the slider about halfway between
the V where the cable split, and the in-ear speakers, then
adjust for your personal comfort. This will keep the cables
in a more compact position, reducing bounce and sway.
To use for the purpose of reducing tangles during storage,
push the Cable Slider all the way up to the in-ear speakers
before putting your Turbine away. Simply push the Cable
Slider back down when ready for use.