MK Products Prince XL MM Com ACWC - Manual (Page 14)

Prince ® XL Millermatic Compatible Gun Owner's Manual - Page 7
615-0621-15 ...............................................................................15ft./4.5m
615-0621-25 ...............................................................................25ft./7.6m
615-0621-35 ..............................................................................35ft/10.7m
615-0621-50 .............................................................................50ft./15.2m
Optional nickle tube liner ................................................................431-2031
Snake Skin ® Velcro ® Closure Cover
Leather Snake Skin ® protective covers are now standard on all guns. You
may order replacement covers to protect the lead assembly of the gun when
the original factory cover becomes damaged or worn. The Velcro ® closure
makes it easy to replace in the field.
Snake Skin Cover 13ft (for 15ft leads)......................................... 931-0110
Snake Skin Cover 23ft (for 25ft leads)......................................... 931-0122
Snake Skin Cover 33ft (for 35ft leads) ........................................ 931-0132
Snake Skin Cover 48ft (for 50ft leads) ........................................ 931-0123
Gas Valve Removal Tool
Gas valve removal is often required to replace the standard valve stem with
a modified valve stem (P/N 431-1080) when placing an older model gun on
a newer model wire feeder. This is performed by using P/N 931-0105 Gas
Valve Removal Tool. This multifunctional tool has been slotted on one side
to encompass and conform to the gas valve stem and seat into the slotted
gas valve body as seen in Figures 1 and 2. Removal of the gas valve can be
accomplished by turning the gas valve tool counter clockwise. Reinstall by
turning clockwise. The tool doubles as a bottle opener.
Section D Maintenance
Maintenance of the gun will normally consist of a general cleaning of the wire
guide system, including tubes, drive rolls, and conduit at regular intervals.
Remove spatter build-up from inside of nozzles with a hardwood stick.
The only parts on the gun that are subject to normal wear are the conduit,
contact tips, gas cups, drive and idler rolls and barrel liners. A supply of
those parts should be maintained on hand.
If repairs do become necessary, qualified shop maintenance personnel can
easily replace any parts.
Your Cobramatic
® System is designed to provide years of reliable service.
Normal wear and component failure may require occasional service.
The number of units in operation and the importance of minimal “down time”
will determine to what extent spare parts should be stocked on hand. See
the “Recommended Spare Parts List” for the most commonly replaced parts.
Maintenance Tools
Tool Part Number
Gas Valve Removal Tool 931-0105
Contact Tip Removal Tool 931-0044
Drive Roll Removal Tool 931-0100
Figure 2 Gas Valve Removal Tool Figure 1