Assembling table legs to extension table, Assembling extension table to front and rear rails – Delta 36-841 User Manual

Page 26

ASSEMBLING TABLE LEGS
TO EXTENSION TABLE

Position the two legs, at the inside of one end of the

extension table, mark the position of the eight holes to be
drilled into the bottom of the table, Fig. 92. Remove the
two legs and using a 1/16" drill bit, drill the eight holes
1/2" deep. Replace the two legs and fasten to the bottom
of the table using the eight 3/4" long wood screws
supplied.

Fasten the leg bracket (L) Fig. 93, to the end piece (J)

of the table using the two 1-1/2" long flat head Phillips
screws, flat washers and hex nuts. Fasten the remaining
leg to the extension table in the same manner.

Fig. 92

Fig. 93

ASSEMBLING EXTENSION TABLE
TO FRONT AND REAR RAILS

Place table assembly (N) Fig. 95, in position between

the two rails, as shown. Make sure end of table (N) is flush
against extension wing (P). Using a straight edge make
sure table (N) is in the same plane and level with saw table
(P). Lightly tap table up or down and adjust leveling
screws (R) Fig. 96, in bottom of legs to accomplish this.
When the table (N) Fig. 95, is level and in the same plane
with saw table (P), drill 1/4" through holes (S) Fig. 95
through the front and rear of the extension table using the
holes provided in rails as template.

After the holes have been drilled in the edge of the

front and rear extension table board, fasten both front and
rear rail to table using the 1-1/2" flat head Phillips screws,
flat washers, and hex nuts (S) Fig. 95.

Fig. 95

Fig. 96