Delta 36-841 - Manual (Page 25)

25
ASSEMBLY INSTRUCTIONS FOR MODEL 78-995
50" COMMERCIAL BIESEMEYER FENCE SYSTEM
ASSEMBLING GUIDE RAILS
1. Assemble the front rail (A) Fig. 88, to front of saw
table using the two 3/8-16 x 1-1/4" long flat head Phillips
screws (B), 7/8" flat washers, lockwashers and 3/8-16
hex nuts supplied. Screws (B) are inserted through the
two holes in the front rail, as shown and through the two
through holes in the front of the saw table and fastened
to the table with the flat washers, lockwashers and hex
nuts. IMPORTANT: Do not completely tighten front rail
mounting hardware at this time.
2. Using template (D) Figures 89 and 90, to check and
adjust front rail at both ends of the saw table as shown,
to make sure rail (A) is parallel with table surface and
tighten rail mounting hardware (B). IMPORTANT:
Template (D) must be on the saw table when check-
ing, not on extension wing.
3. Assemble rear rail (E) Fig. 91, to rear of saw table
using the two 3/8-24 x 1-1/4" long hex head screws (F),
7/8" O.D. flat washers, and lockwashers as shown.
NOTE: When mounting, the two screws (F) are threaded
into the threaded holes in the saw table, as shown.
4. Make certain top edge of rail (E) Fig. 91 is below table
surface and that top edge of cut-outs (G) are below miter
gage slots before tightening screws (F).
Fig. 88
Fig. 89
Fig. 90
Fig. 91
A
B
B
D
A
B
D
A
B
E
G
G
F