Meinberg PZF600 - Manual (Page 13)

13
Menu OUTP ENA
This menu defines when the output signals are enabled after powering up the system.
The following settings are possible: output signal generation starts immediately after
reset (always), or the clock has to synchronize first before the signals are enabled (after
sync). This selection can be done separately for the pulse outputs (PLS), the serial
interfaces (SER) and the programmable synthesizer (SYN). After pressing Set the
following content is displayed:
Pushing Set again, the option on the right side starts blinking. Selection of the available
options (alw and asy) is made with Set as well. To make this selection also for the other
output signals, Menu must be pushed once. When this enabling is defined for all output
signals, the configuration ist stored by keeping Set pressed for a while. The sub menu is
displayed again.
Menu SYNTH.
The output frequency of the internal synthesizer is selected in this menu. This can be
done in the range of 1/3Hz to 9.999MHz.
The frequency can be set here and the buttons are used the same way as for setting the
DIST.o.T-value. In addition, the range of the frequency is defined and eiter xxx.xHz,
x.xxxkHz, xx.xxkHz, xxx.xkHz or x.xxxMHz can be selected. In the first range (Hz)
only the fractional digits 1/3Hz, 0.5Hz and 2/3Hz are accepted. After the frequency is
entered the value becomes valid and is stored in the battery buffered RAM just after the
Menu-button is pressed a longer time. Note: the sinewave output of the synthesizer
provides an acceptable output signal not above 100kHz.
Menu TIME REF
The displayed timezone can be set in this menu. Possible selections are:: UTC, MEZ/
MESZ and MEZ (without daylight saving).