Meinberg PZF600 - Manual (Page 11)

11
Menu DATE
After Set is pressed, the actual date appears on the display.
Menu DAY o.W.
The day of the week will be displayed in this menu.
Menu PZF STAT
Information on the decoding of the pseudo-random sequence is available in this menu.
The following content may be displayed:
This message indicates that the system tries to achieve a coarse synchronisation. This
procedure starts after power-up or worse receiption for more than ten seconds. If the
coarse synchronisation was successfull, the receiver enters the state of fine-correlation.
The system tries to lock the received PZF as exact as possible to generate a precise time
frame. The display shows the correlation coefficient at the end of each second, which can
be up to 100%. A high value for the coefficient should be achieved by choosing a
suitable position for the antenna.
The essential part of the tracking is completed five seconds after "FC: xx%" appeared.
Tracking steps of three microseconds are possible each second until the internal realtime
clock is synchronized (two minutes max.). Afterwards, corrections of the time frame are
executed per minute only. The direction of these steps is displayed by the characters '>' or
'<' behind the digits of the correlation coefficient.