Measurement Computing 488/p rev.1.0 - Manual (Page 5)

Specifications
RS-232 INTERFACE:
Duplex: Full
Data Bits: 8 bit ASCII
Stop Bits: 1 or 2
Parity: None
Baud Rate: 9600
Terminator: All terminators received on the serial port are automatically
transmitted on the IEEE 488 port
Handshaking: Supports Clear To Send (CTS) and Request To Send (RTS)
Serial I/O Buffers: 120 character input buffer
Connector: Accepts 25-pin Sub-D male (DB25P)
IEEE 488 INTERFACE:
Addressing: Communicates with an IEEE 488 device set to address 05
Terminator: Transmits all terminators received from serial port
Connector: Plugs directly into a standard IEEE 488 female receptacle,
either directly on an IEEE 488 device or on a cable
GENERAL:
Power: Draws less than 5mA from the DTR or DSR serial lines on the host computer
Environment: 0° to 50°C; 0 to 90% RH non-condensing
Dimensions: 50mm deep x 60mm wide x 25mm high 2"x2.3"x0.9")
Weight: 50.2g (1.8 oz.)
6SHFLILFDWLRQV VXEMHFW WR FKDQJH ZLWKRXW QRWLFH
Warranty
IOtech, Inc. warrants this product to be free from defects in material and
workmanship. Our obligation under this warranty is to repair or replace, at our
option, any product or part thereof which proves defective upon examination within
the time period indicated on the product warranty card from the time of shipment.
No other warranty is expressed or implied.
For service or applications assistance, contact the factory:
IOtech, Inc.
25971 Cannon Road
Cleveland, Ohio 44146
Tel: (440) 439-4091
Fax: (440) 439-4093