Measurement Computing Parallel488 - Manual (Page 16)

Section 2 Getting Started
2.4
SW1 View for Auto-Linefeed Selection
OPEN
1 2 3 4 5 6 7 8 DOT
Switch
Side
View
OPEN
1 2 3 4 5 6 7 8
Auto-Linefeed Disabled Auto-Linefeed Enabled
2.2.3 Mode Selection
The Parallel488 mode is selected with SW1-7 in either the parallel to IEEE
mode (described in Section 3), or the IEEE to parallel mode (described in Section
4). The product operates in only one of two modes, and cannot communicate in
both modes simultaneously. The factory default is the parallel to IEEE mode.
SW1 View for Mode Selection
OPEN
1 2 3 4 5 6 7 8 DOT
Switch
Side
View
OPEN
1 2 3 4 5 6 7 8
IEEE to Parallel Mode Parallel to IEEE Mode
2.3 Operation
After setting the Parallel488 to the proper switch selections and reassembling the
unit, plug the power supply connector into the rear jack on the interface.
CAUTION
Never install the power supply into the interface while it is
connected to AC line power. Failure to observe this caution
may
result in damage to the Parallel488.