Measurement Computing Parallel488 - Manual (Page 14)

Section 2 Getting Started
2.2
SW1 Factory Default Settings
10
Parallel to IEEE
OPEN
1 2 3 4 5 6 7 8
IEEE Address
Auto Linefeed
Mode
Disabled
DOT
Switch
Side
View
To modify any of these defaults, follow this simple procedure:
Disconnect the power supply from the AC line and from the interface.
Disconnect any IEEE or parallel cables prior to dissassembly.
WARNING
Never open the Parallel488 case while it is connected
to the AC line. Failure to observe this warning may
result in equipment failure, personal injury or death.
Remove the four screws located in each corner of the rear panel. Hold the case
firmly and pull the rear panel outward, noting the slot location of the main circuit board.
Modify those parameters which are
appropriate for your installation and reassemble the
unit. Slide the main circuit board into the previously noted slot and finish reassembly by
tightening the four screws into the rear panel.