Daq pc-card p1analog i/o, Daq pc-card, Analog i/o – Measurement Computing Daq PC-Cards User Manual
Page 19
Daq PC-Card
P1
Analog I/O
Pin
Signal Name
Description for P1 Pin Use in the Daq PC-Card
1 Not
Connected
--
2 Not
Connected
--
3
OP 3
Digital out bit 3
4
OP 1
Digital out bit 1
5
IP 3
Digital in bit 3
6
IP 1
Digital in bit 1
7 Not
Connected
--
8 Not
Connected
--
9 Reserved
--
10 Reserved
--
11
CH 7 LO IN / CH 15 HI IN
Ch 7 LO IN (differential mode), or Ch 15 HI IN (single ended mode)
12
CH 6 LO IN / CH 14 HI IN
Ch 6 LO IN (differential mode), or Ch 14 HI IN (single ended mode)
13
CH 5 LO IN / CH 13 HI IN
Ch 5 LO IN (differential mode), or Ch 13 HI IN (single ended mode)
14
CH 4 LO IN / CH 12 HI IN
Ch 4 LO IN (differential mode), or Ch 12 HI IN (single ended mode)
15
CH 3 LO IN / CH 11 HI IN
Ch 3 LO IN (differential mode), or Ch 11 HI IN (single ended mode)
16
CH 2 LO IN / CH 10 HI IN
Ch 2 LO IN (differential mode), or Ch 10 HI IN (single ended mode)
17
CH 1 LO IN / CH 9 HI IN
Ch 1 LO IN (differential mode), or Ch 9 HI IN (single ended mode)
18
CH 0 LO IN / CH 8 HI IN
Ch 0 LO IN (differential mode), or Ch 8 HI IN (single ended mode)
19
L.L. GND
Low level ground (analog ground; for use with analog inputs)
20 Not
Connected
--
21 Not
Connected
--
22
OP 2
Digital output bit 2
23
OP 0
Digital output bit 0
24
IP 2
Digital input bit 2
25
IP 0
Digital input bit 0
26
Active Scan
Active Scan
27 Reserved
--
28
L.L. GND
Low level ground (analog ground; for use with analog inputs)
29
L.L. GND
Low level ground (analog ground; for use with analog inputs)
30
CH 7 HI IN
Ch 7 HI IN (single ended mode, or differential mode)
31
CH 6 HI IN
Ch 6 HI IN (single ended mode, or differential mode)
32
CH 5 HI IN
Ch 5 HI IN (single ended mode, or differential mode)
33
CH 4 HI IN
Ch 4 HI IN (single ended mode, or differential mode)
34
CH 3 HI IN
Ch 3 HI IN (single ended mode, or differential mode)
35
CH 2 HI IN
Ch 2 HI IN (single ended mode, or differential mode)
36
CH 1 HI IN
Ch 1 HI IN (single ended mode, or differential mode)
37
CH 0 HI IN
Ch 0 HI IN (single ended mode, or differential mode)
(1) Only use Daq PC-Card with passive DBK cards or modules.
(2) No power or analog output is available from P1.
Daq PC-Card User’s Manual
928596
Installation 2-9