Measurement Computing USB-TC - Manual (Page 8)

8
Chapter 2
Installing the USB-TC
What comes with your shipment?
The following items are shipped with the USB-TC:
Hardware
 USB-TC
 USB cable
Software
 MCC DAQ CD
Documentation
In addition to this hardware user's guide, you should also receive the Quick Start Guide. This booklet provides
an overview of the MCC DAQ software you received with the device, and includes information about installing
the software. Please read this booklet completely before installing any software or hardware.
Unpacking
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the USB-TC from its packaging, ground yourself using a wrist strap or by simply
touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, contact us immediately using one of the following methods:
 Knowledgebase: kb.mccdaq.com
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
For international customers, contact your local distributor. Refer to the International Distributors section on our
website at
www.mccdaq.com/International .
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is
available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf .
Installing the hardware
To connect the USB-TC to your system, turn your computer on, and connect the USB cable to a USB port on
your computer or to an external USB hub that is connected to your computer. The USB cable provides power
and communication to the USB-TC.
When you connect the USB-TC to a computer for the first time, a Found New Hardware dialog opens when the
operating system detects the device. When the dialog closes, the installation is complete. The USB LED should
blink and then remain on. This indicates that communication is established between the USB-TC and your
computer.
Caution! Do not disconnect any device from the USB bus while the computer is communicating with the
USB-TC, or you may lose data and/or your ability to communicate with the USB-TC.