Measurement Computing USB-202 - Manual (Page 7)

7
Chapter 2
Installing the USB-202
Unpacking
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the device from its packaging, ground yourself using a wrist strap or by simply
touching the computer chassis or other grounded object to eliminate any stored static charge.
Contact us immediately if any components are missing or damaged.
Installing the software
Refer to the MCC DAQ Quick Start for instructions on installing the software on the MCC DAQ CD. Refer to
the device product page on the Measurement Computing website for information about the included and
optional software supported by the USB-202.
Install the software before you install your device
The driver needed to run the USB-202 is installed with the software. Therefore, you need to install the software
package you plan to use before you install the hardware.
Installing the hardware
Connect the USB cable to an available USB port on the computer or to an external USB hub connected to the
computer. Connect the other end of the cable to the USB connector on the device. No external power is
required.
When connected for the first time, a Found New Hardware dialog opens when the operating system detects the
device. When the dialog closes, the installation is complete. The device Status LED turns on after the device is
successfully installed.
If the Status LED turns off
If communication is lost between the device and the computer, the Status LED turns off. To restore
communication, disconnect the USB cable from the computer and then reconnect it. This should restore
communication, and the
Status LED should turn on.
Calibrating the hardware
Factory calibration
The Measurement Computing Manufacturing Test department performs the initial factory calibration. Return
the device to Measurement Computing Corporation when calibration is required. The recommended calibration
interval is one year.
Field calibration
Field calibration is not supported.