Measurement Computing PCIM-DAS1602/16 - Manual (Page 24)

PCIM-DAS1602/16 User's Guide Specifications
Accuracy
Typical accuracy ±1 LSB
Absolute accuracy ±2 LSB
Accuracy Components
Gain error
Trimmable by potentiometer to 0
Offset error Trimmable by potentiometer to 0
Integral linearity error ±0.5 LSB typ, ±1 LSB max
Differential linearity error ±0.5 LSB typ, ±1 LSB max
Total board error is a combination of gain, offset, differential linearity and integral linearity error. The
theoretical absolute accuracy of the board may be calculated by summing these component errors. Worst case
error is realized only in the unlikely event that each of the component errors are at their maximum level, and
causing error in the same direction.
Analog output drift
Analog output full-scale gain drift ±0.22 LSB/°C max
Analog output zero drift ±0.22 LSB/°C max
Overall analog output drift ±0.44 LSB/°C max
Absolute error change per °C temperature change is a combination of the gain and offset drift of many
components. The theoretical worst case error of the board may be calculated by summing these component
errors. Worst case error is realized only in the unlikely event that each of the component errors are at their
maximum level, and causing error in the same direction.
Digital input / output
Digital I/O connector
Digital type 82C55
Number of I/O 24
2 banks of 8 and 2 banks of 4 or
3 banks of 8 or
Configuration per 82C55
2 banks of 8 with handshake
Input high 2.0 volts min, 5.5 volts absolute max
Input low 0.8 volts max, -0.5 volts absolute min
Output high 3.0 volts min @ -2.5 mA
Output low 0.4 volts max @ 2.5 mA
Power-up / reset state Input mode (high impedance)
Pull-up/pull-down resistors User installed. Dual footprint allows pull-up or pull-down configuration
Main connector
Digital output type 74LS244, power up / reset to LOW logic level
Digital input type 74LS373, pulled to logic high via 10 K resistors
Number of I/O 8
Configuration 4 fixed input, 4 fixed output
Output high 2.7 volts @ -0.4 mA min
Output low 0.5 volts @ 8 mA max
Input high 2.0 volts min, 7 volts absolute max
Input low 0.8 volts max, -0.5 volts absolute min
5-4