Programming and developing applications, Programming languages, Packaged applications programs – Measurement Computing PCI-INT32 User Manual
Page 10: Register-level programming, Programming and developing applications -1, Programming languages -1, Packaged applications programs -1, Register-level programming -1
Chapter 3
Programming and Developing Applications
After following the installation instructions in Chapter 2, your board should now be installed and ready for use.
Programming languages
Measurement Computing’s Universal Library™ provides access to board functions from a variety of Windows
programming languages. If you are planning to write programs, or would like to run the example programs for
Visual Basic
or any other language, please refer to the Universal Library User's Guide (available on our web
).
Packaged applications programs
Many packaged application programs, such as SoftWIRE
, Labtech Notebook™, and HP-VEE™, now have
drivers for your board. If the package you own does not have drivers for your board, please fax or e-mail the
package name and the revision number from the install disks. We will research the package for you and advise
how to obtain drivers.
Some application drivers are included with the Universal Library package, but not with the application package.
If you have purchased an application package directly from the software vendor, you may need to purchase our
Universal Library and drivers. Please contact us by phone, fax or e-mail:
!
Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
!
Fax: 508-946-9500 to the attention of Tech Support
!
Email:
Register-level programming
You should use the Universal Library or one of the packaged application programs mentioned above to control
your board. Only experienced programmers should try register-level programming.
If you need to program at the register level in your application, refer to the Register Map for the PCI-INT32.
This document is available on our web site at
3-1