Measurement Computing CIO-DDA06 - Manual (Page 17)

Chapter 5
Specifications
Typical for 25 °C unless otherwise specified.
Specifications in italic text are guaranteed by design.
Analog output
Table 1. Analog output specifications
D/A converter type AD7237
Resolution 12-bits
Number of channels 6
Output ranges Bipolar: ±10 V, ±5 V, ±2.5 V, ±1.67 V
Unipolar: 0 to 10 V, 0 to 5 V, 0 to 2.5 V, 0 to 1.67 V
Each channel is independently switch-selectable.
Offset error Trimmable to zero
Gain error Trimmable to zero
Differential nonlinearity ± ½LSB max
Integral nonlinearity ± ½LSB max
Monotonicity ± ½LSB max
D/A gain drift ±15 ppm/°C typical, ±30 ppm/°C max
D/A bipolar offset drift ±7 ppm/°C typical, ±15 ppm of FSR/°C max
D/A unipolar offset drift ±1 ppm/°C typical, ±3 ppm of FSR/°C max
D/A settling time (20 V step to ±0.01%) 5 µs typ, 10 µs max
Slew rate 5 V/µs
Current drive ±5 mA
Output short-circuit current 20 mA indefinite
Output coupling DC
Output impedance 0.1 Ohms max
D/A pacing Software paced
D/A trigger modes Software
Data transfer Programmed I/O
Throughput System dependent
Miscellaneous ƒ Double buffered output latches
ƒ Update DACs individually or simultaneously (jumper selectable by pairs)
ƒ Power up and reset option, jumper selectable (revision 3 and up): With
jumper set to "ZERO", all DAC's cleared to 0 volts, ±32 mV, DACs set to
simultaneous update mode until first read. With jumper set to "STD", DAC
output on power-up is undefined.
17