Measurement Computing CIO-DAS08/JR - Manual (Page 10)

CIO-DAS08/JR User's Guide Installing the CIO-DAS08/JR
10
Hex Range Function Hex Range Function
080-08F DMA page registers 310-31F Prototype card
0A0-0A1 8259 PIC #2 (AT) 320-32F Hard disk (XT)
0A0-0AF NMI mask (XT) 378-37F Parallel printer
0C0-0DF 8237 #2 (AT) 380-38F SDLC
0F0-0FF 80287 numeric CO-P (AT) 3A0-3AF SDLC
1F0-1FF Hard disk (AT) 3B0-3BB MDA
200-20F Game control 3BC-3BB Parallel printer
210-21F Expansion unit (XT) 3C0-3CF EGA
238-23B Bus mouse 3D0-3DF CGA
23C-23F ALT bus mouse 3E8-3EF Serial port
270-27F Parallel printer 3F0-3F7 Floppy disk
2B0-2BF EGA 3F8-3FF Serial port
Installing the CIO-DAS08/JR
After you configure the board's switches and jumpers, you can install the CIO-DAS08/JR into your computer.
To install your board, follow the steps below.
Install the MCC DAQ software before you install your board
The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install
the MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on
installing the software.
1. Turn your computer off, open it up, and insert your board into an available ISA slot.
2. Close your computer and turn it on.
3. To test your installation and configure your board, run the InstaCal utility you installed in the previous
section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-
Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.
Connecting the board for I/O operations
Connectors, cables – main I/O connector
The table below lists the board connector, applicable cables, and compatible accessory products.
Board connector, cables, and accessory equipment
Connector type 37-pin D type connector
Compatible cable C37FF-x
DFCON-37 (mating connector)
Compatible accessory products with
the C37FF-x cable CIO-MINI37
CIO-LAB8-TERM
Information on signal connections
General information regarding signal connection and configuration is available in the Guide to Signal
Connections (available at
www.mccdaq.com/signals/signals.pdf) .