MEGA Corp. MES34-OPS-1 - Manual (Page 5)

MES34-OPS-1
21 Feb 2014
SECTION 1
Definitions and Abbreviations
1-2
SAFETY MESSAGES
There are several specific safety messages on this
machine. The exact location of the hazards and
description of the hazards are reviewed in this
section. All personnel working on or operating the
machine must become familiarized with all the safety
messages.
Make sure that all of the safety messages are legible.
Clean the safety messages or replace the safety
messages in you cannot read the words. Replace the
illustrations if the illustrations are not legible. When
you clean the safety messages, use a cloth, water and
soap. Do not use solvent, gasoline or other harsh
chemicals to clean the safety messages. Solvents,
gasoline or harsh chemicals could loosen the
adhesive that secures the safety messages. Loose
adhesive will allow the safety messages to detach.
Replace any safety message that is damaged or
missing. If a safety message is attached to a part that
is replaced, install a new safety message on the
replacement part.
DO NOT OPERATE (1)
This safety label is located on the outside of the cab.
Do not open this control box unless you read and
understand the instructions and warnings in the
Operator and Maintenance Manual. Failure to
follow instructions or heed the warnings could
result in serious injury or death.
BACKING RUNOVER HAZARD (2)
This safety label is located on the rear of the scraper
and inside the cab.
The vehicle is equipped with a back-up alarm.
Alarm must sound when operating this vehicle in
reverse. Failure to maintain a clear view in the
direction of travel could result in serious injury or
death.
FALL HAZARD (3)
This safety label is located at the top of the scraper.
Ensure PPE fall arrest harness is worn, adjusted
properly and attached to an anchor point when
performing maintenance on top of the MES34 or
when fall hazards are present. Failure to use PPE
when fall hazards are present may result in
serious personnel injury or death.