beautypg.com

Placement of the mounting plate, Finding the wall studs, Installation instructions – Maytag MMV1153BAB Installation User Manual

Page 8

background image

Installation Instructions

8

A.

REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE

1.

Remove the installation instructions, Exhaust
adaptor, filters, glass tray and the small hardware
bag. Do not remove the Styrofoam protecting the
front of the oven.

2.

Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.

3.

Pull the carton up and off the oven.

4.

Remove and properly discard plastic bags.

5.

Remove the 2 screws from the mounting plate.
This plate will be used as the rear wall template
and for mounting.

NOTE: You will have to reuse two screws in original
location of outcase after removing mounting plate.

B.

FINDING THE WALL STUDS

1.

Find the studs, using one of the following
methods:

A. Stud finder–a magnetic device which locates

nails.

OR

B. Use a hammer to tap lightly across the

mounting surface to find a solid sound. This
will indicate a stud location.

2.

After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs
should be 16" or 24" from this mark.

3.

Draw a line down the center of the studs.

THE MICROWAVE MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.

Carton

Styrofoam

Screws

Screws

Mounting Plate

Wall Studs

Center

1.PLACEMENT OF THE MOUNTING PLATE