Maytag MMV1153BAB Installation - Manual (Page 15)

Installation Instructions
15
B2. USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
3.
Carefully slide the blower motor toward the right,
and lift it partially out of the opening.
Note: The blower wires are long enough to allow
flexible handling while performing these steps.
Disconnect the wires if necessary for additional
flexibility.
4.
Remove the two screws holding the left side inlet
sleeve to the blower unit. Snap the inlet sleeve
off of the blower.
5.
Roll the blower unit so that the right exhaust
outlet faces the top. Snap the inlet sleeve back
onto the left side with the opening facing down.
Note: The left side sleeve opening must always
face downward. Reinstall the 2 screws holding
the inlet sleeve to the motor assembly.
6.
Tilt and place the blower unit back into the
opening in the top of the microwave.
Remove
screws
B3. ADAPTING MICROWAVE
BLOWER FOR OUTSIDE TOP
EXHAUST
1.
Remove the back top center blower motor door
retaining screw.
2.
Open the blower motor door by lifting it up at the
back side of the microwave. Remove and save
the top and back retaining screws that hold the
blower motor in the microwave.
Blower Motor Back of
Microwave
Blower Motor
Screw
Retaining
Screw
Retaining
Screw