beautypg.com

Recirculating, Installation instructions, Non-vented ductless) a1 – Maytag MMV1153BAB Installation User Manual

Page 12

background image

Installation Instructions

12

A.

RECIRCULATING

(Non-Vented Ductless)

A1.

ATTACH THE MOUNTING PLATE
TO THE WALL

Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.

1.

Remove the toggle wings from the bolts.

2.

Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to ¾ " onto each bolt.

To use toggle bolts:

3.

Place the mounting plate against the wall and
insert the toggle wings into the holes on the wall
to mount the plate.

NOTE: Before tightening toggle bolts and wood
screw, make sure to coincide bottom line of the
Mounting plate with Horizontal line of “Rear wall
Template” and then the Mounting plate is properly
centered under the cabinet.

CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.

4.

Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.

A2.

USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET

You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.

Read the instructions on the TOP CABINET
TEMPLATE.

Tape it underneath the top cabinet.

Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.

CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.

INSTALLATION OVERVIEW

A1. Attach Mounting Plate to Wall

A2. Prepare Top Cabinet

A3. Mount the Microwave Oven

Wall

Toggle Wings

Toggle
Bolt

Bolt End

Spacing for Toggles More
Than Wall Thickness

Mounting
Plate