Maytag MMV5100AAB Installation - Manual (Page 15)

15
• Raise the flap on Carton B as shown and carefully slide microwave oven up
with Carton B until it hangs on support tabs at the bottom of mounting plate.
NOTE: There are holes on back of microwave oven. The arm on mounting
plate should fit into these holes until the microwave oven touches and
hooks onto the wall.
• Rotate microwave upward so that top of oven is against bottom of upper
cabinet or cabinet frame.
• Drop a phillips screw driver into hole N from above and push it down as far
as it will go. Pull the screw driver towards you until the gap between the
upper cabinet and microwave oven is closed. Place washers over two
1 /
4
" x
3" bolts. Insert bolt down through each hole in the upper cabinet bottom.
Remove screw driver and tighten two bolts with a screw driver.
• Coil power supply cord through clamp. Secure clamp to cabinet side with
mounting screw.
1
2
Arm
Support tabs
Screw driver
1
/
4
" x 3” bolt with
washer
1 /
4
" x 3” bolt
with washer
Clamp
OTR-Installation-M1.fm Page 15 Wednesday, September 27, 2000 4:03 PM