Maytag MMV5100AAB Installation - Manual (Page 13)

13
MOUNT THE MICROWAVE OVEN
Carton will be used in order to assist positioning the microwave oven during
mounting.
• Measure the height from cooking surface (or countertop) to the bottom
edge of the top cabinet.
• Cut out carton A along one of the dotted lines . Determine the correct line
according to the height you just measured (Fig. 1).
Example: If the height is 33", cut the line marked 33".
If the correct height is not shown on the box, draw a line between the
two closest lines. For example, if the height is 32", draw a line 2" below
the line marked 30", and then cut the box along the line you have drawn.
• Cut out carton B (Fig. 1) along the dotted line . Then remove staple on
the bottom of carton B (carton B’, Fig. 2).
• Place cut portion of Carton A on top of the range.
NOTE: Prepare phillips screw driver, bolts and washers on top of the upper
cabinet. Protection of the range cooking surface is recommended.
If the dimension is over 36” , do not use carton. At least two people will be
required to lift and mount the microwave oven.
,,
Measure here
A
A
Carton A
Carton B’
30”
33”
36”
Fig. 1
Fig. 2
Carton B
B
OTR-Installation-M1.fm Page 13 Wednesday, September 27, 2000 4:03 PM