Directed Electronics 2.2 - Manual (Page 24)

24 © 2008 Directed Electronics. All rights reserved.
command operations. When locked, if any command button is
pressed the remote emits an error tone.
The keypad lock feature is Off when the remote beeps twice and
•
the keypad does not lock.
If the keypad lock is On, press
AUX
, and then press
AUX
to unlock the
keypad.
Note:
If the auto keypad lock feature is programmed On, the remote un-
locks when the vehicle ignition is turned Off. The remote stays unlocked
to allow time to exit and unload the vehicle, and then lock the doors
with the remote. When the
A U X
button is pressed, the keypad auto lock
feature resumes normally.
Remote Beeps feature
Press the
AUX
button to turn the Remote Beeps feature On and Off.
When the remote beeps once, the feature is on, the remote then beeps
when pressing any button on the remote or when programming features
on the remote.
When the remote beeps twice, the feature is off, the remote does not
beep when pressing any button on the remote but does beep when
programming features on the remote.
➤
Panic mode
If you are threatened in or near your vehicle, you can attract attention by
triggering the system with your transmitter. Just press
A U X
for 2 seconds,
and you will enter Panic Mode. The siren will sound and the parking
lights will flash for the programmed siren duration. To stop Panic Mode
at any time, press
A U X
on the remote transmitter again.