Directed Electronics 2.2 - Manual (Page 23)

23 © 2008 Directed Electronics. All rights reserved.
At anytime during the next 10 seconds, press and
release the Valet switch. Now the Status LED lights
constantly if you have entered Valet® Mode, and
go out if you have exited Valet Mode.
To enter or exit Valet mode with the remote control:
Press
AUX
two times, and then
AUX
to put the system into/out of Valet
Mode.
Note:
The LED on the control center turns on solid when in Valet Mode
and shuts off when exiting Valet Mode.
➤
Remote feature programming
The remote control has a menu for configuring user features. Before you
start make sure the keypad is unlocked. (See page 13)
To program the remote user features:
Press and hold the 1.
AUX
button on the remote for 12 seconds. (ig-
nore the car indicator at 3 seconds). The remote emits one long
beep, and the trasmit LED turns on to indicate the Main Menu.
Press and hold the
2.
AUX
button for 1. 5 seconds: The remote beeps
two-tmes. You are now in the Remote Configuration menu.
To configure the remote control features:
Press, and then release the command button. The remote beeps to 1.
indicate the feature configuration.
Press the
2.
AUX
button to access the Auto keypad lock feature.
Press the 3.
A U X
button to change the Auto keypad lock feature.
When the remote beeps once the keypad automatically locks •
6o seconds after the last button operation to avoid accidental