Mathey Dearman Maxi Jolli Chain Machine User Manual
Page 11
10
4.5.6
Set fuel gas and oxygen regulator pressure per the regulator manufacturer’s instructions.
4.6 - MANUAL MAXI JOLLI CHAIN MACHINE CUTTING PROCESS
4.6.1
Follow the instruction listed in section 4.1 through 4.5.
4.6.2
Light the gas torch per the manufacturer’s instructions.
4.6.3
Rotate the crank handle (Figure 3 Item 24) back and forward preheating the pipe to the desired
temperature per the torch manufacturer’s instructions.
4.6.4
Rotate the Crank Handle (Figure 5 Item 24), while applying the Cutting Oxygen to the oxy/fuel Torch
to minimize notching of the pipe.
4.6.5
Rotate the Crank Handle (Figure 5 Item 24) until the torch has completed the cut. A smooth
consistent rotation of the crank handle is necessary to produce a smooth cut.
4.6.6
Turn off the cutting oxygen valve as soon as the cut per the torch manufacturer’s instructions.
4.6.7
Turn of the gas and oxygen to the gas torch per the torch manufacturer’s instructions
4.7 - 230VAC MOTORIZED MAXI JOLLI CHAIN MACHINE CUTTING PROCESS
4.7.1 Follow the instruction listed in section 4.1 through 4.5
4.7.2
Depress the emergency stop switch on the motor control box.
FIGURE 3
4.7.3
Move the forward / stop / reverse switch to the center or off position.
4.7.4
Connect the motor control box to the Right Angle drive motor (22/B).
4.7.5 Connect the motor control box to the 230vac power source.
4.7.6 Twist to release the emergency stop switch.
4.7.7 Move the forward / stop / reverse switch to the forward or reverse position to check functionality
of the equipment.
4.7.8
Increase the speed rheostat as needed to check functionality of the equipment.
4.7.9
Depress the emergency stop switch on the motor control box.
4.7.10 Move the forward / stop / reverse switch to the center or off position.
4.7.11 Move the speed rheostat dial to the 3 position.
WARNING: Never stand in front of the oxygen and fuel gas regulator when
adjusting the pressure
WARNING: When connecting the motor control box to the 230vac power
source, there is a risk of sever electrical shock or death.