Marantz VP-10S1 - Manual (Page 6)

2
ENGLISH
• Hold the projector by the grooves in the bottom when
relocating. Work in group of 4 or more to carry the projector.
• Ensure sufficient space around the projector when
relocating the unit. Do not carry the projector through narrow
places, up/down stairs or anywhere that poses danger.
• Never drag or roll the projector when relocating the unit.
• Unplug the AC power cable and disconnect any other
cables from the projector before relocating the unit.
• If the projector is hung from a ceiling or installed in a high
place, do not detach and relocate the unit yourself.
Contact your nearest Marantz Authorized Dealer or
Service Center.
• This projector is heavy. Use due caution not to drop it or
strain your back when lifting the unit.
• If installing the projector on a flat surface, select a location
that is level, stable and sturdy enough to support the
projector’s weight.
• Keep the projector 11 13/16 inch (30 cm) or more from
walls and other equipment when installed. If locating in a
rack or similar arrangement, ensure a clearance of 3
15/16 inch (10 cm) or more from the top surface of the
equipment below it as well as a clearance of 11 13/16
inch (30 cm) or more from objects on all sides.
• To hang the projector from a ceiling, contact the Marantz
Authorized Dealer or Service Center. To ensure safe
installation, the ceiling must be reinforced to support the
projector’s weight. Do not install the projector yourself.
Hanging the projector from the ceiling requires a
separately solder hanger and pole.
• Use a 100-120V/220-240V AC, 50/60 Hz, 5 A power
supply to run the projector.
• To maintain projector performance, do not install the
projector in humid, dusty or smoky places.
• Do not install the projector in extremely hot or cold places.
Operating temperature : 50°F to 95°F (10°C to 35°C)
Storage temperature
: -4°F to 140°F (- 20°C to +60°C)
Altitude : 0 to 4,900 ft (0 to 1,500 m)
above sea level
• If installed on a flat surface, keep objects off the projector.
• If installed on a ceiling, do not hang from or hook anything
on the projector.
• Never look directly into the lamp with unprotected eyes
while lit.
• Never directly expose skin to the light of the lamp.
• When used in a dark room, the projected images (special
images, flashing lights and images, flashing vivid reds,
inverted images of strong contrast, sudden scene
changes, etc.) may have harmful effects on viewers. Keep
the room as bright as possible for viewing and watch from
a suitable distance.
• The vent, lamp cover and adjacent areas may get
extremely hot during use. Do not touch these areas
during use as it may result in burns.
Also, wait at least 60 min after shutting off the power for
the projector to cool down.
• If the cooling fan vent is blocked, a protective circuit trips
and automatically shuts off the lamp. However, there is
nothing wrong with the equipment. In such case, unplug
the AC power cable from its electrical outlet and wait at
least 10 min. Then, remove the obstruction from in front of
the vent and plug the power cable back into its electrical
outlet. The projector will resume normal operation.
• This projector is not intended for business use. Marantz
assumes no responsibility whatsoever for damages
caused directly or indirectly during use for business
purposes or by trouble that occurs during such use.
Precautions in Operation
95˚F
(+35˚C)
50˚F
(+10˚C)
Precautions in Installation
Precautions in Relocation
PRECAUTIONS IN USE
Hold projector by this groove.