Marantz VP-10S1 - Manual (Page 20)

16
ENGLISH
You can connect this projector to an HD-Video or PC using the RGB IN jack as well as to a satellite, cable tuner or PC using the
DVI-D input jack.
1. Connect one end of an RGB cable (or DVI-D cable) to the RGB IN jack (or DVI-D IN jack) on the projector rear.
2. Connect the other end of the cable to the RGB output jack of the HD-Video or PC (or the DVI-D output jack of the satellite,
cable tuner or PC).
Note : To project images from a device connected to the DVI-D jack, do as follows. The images can be distorted if you do not
follow the procedure. For details on DVI-D jack of the connected device, see the instruction manual of that device.
1. Turn on power to the projector. (
☞
pg. 17)
2. Set the Input signal of the projector to AUX (DVI-D IN). (
☞
pg. 21)
3. Turn on power to the device (i.e. DVD player) connected to the projector’s DVI-D jack.
You can control an entire home theater system using a PC and Marantz receiver equipment.
To install the below system, contact your nearest Marantz Authorized Dealer or Service Center.
RS-232C DVI-D IN RGB IN
EXT. INT.
IN
OUT
OFF ON
1
2
TRIG. LIGHT REMOTE
VIDEO IN S-VIDEO IN COMPONENT VIDEO IN 1 COMPONENT VIDEO IN 2
Y P B /C B P R /C R Y P B /C B P R /C R
REMOTE CONTROL IN
REMOTE CONTROL OUT
RS-232C
Connecting to a Home Theater System
RS-232C DVI-D IN RGB IN
EXT. INT.
IN
OUT
OFF ON
1
2
TRIG. LIGHT REMOTE
VIDEO IN S-VIDEO IN COMPONENT VIDEO IN 1 COMPONENT VIDEO IN 2
Y P B /C B P R /C R Y P B /C B P R /C R
Connecting to an HD-Video, Satellite, Cable Tuner or PC
RGB (D-Sub monitor) cable
(commercially available)
HD-Video / Satellite
/ Cable Tuner
Monitor output
IBM VGA or
Compatible PC
RGB OUT
or
DVI-D out
RGB OUT
or
DVI-D out
DVI-D cable (commercially available)
RS-232C cable
(straight type,
commercially available)
External Controller
Screen
3.5mm Mini Plug (Mono)
(commercially available)
Control Adapter cable
(commercially available)
Receiver equipment
Control Adapter cable
(supplied)