Datalogic Scanning Industrial PDA - Manual (Page 14)

Setting Up the Mobile Computer
12 Pegaso™ Industrial PDA with Windows
®
CE
Charging with a Battery Charger
The Pegaso is available with a Four-Slot Battery Charger. Use the Battery
Charger to charge batteries independently of the unit.
Figure 4. Four-Slot Battery Charger
Backup Battery
The rechargeable 3.7V Lithium Backup Battery receives its charge from the Bat-
tery Pack. To retain date, time, data, and other settings for the Pegaso, maintain
at least a minimal charge on the Battery Pack.
To maximize the backup battery usable life always store the unit with a main
battery installed or place the unit in a charging dock when not in use.
When the backup battery is low, an icon will display on the status bar (see
Table 1 on page 8 ), and a dialog box will open to alert you.
Setting Up the Mobile Computer
At first use or cold reset, the unit will go through an initial bootup sequence:
1. Touchscreen Calibration on page 13.
2. Getting Connected on page 13.
3. IP Network Setup on page 13.
4. Setting the Date and Time on page 15.
LEDs