Marantz PM5003 - Manual (Page 7)

4
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTION
REMOTE CONTROLLER
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND FUNCTIONS
ENGLISH
NAMES AND FUNCTIONS
FRONT PANEL
PHONES PHONES
MIN MIN MAX MAX
LOUDNESS LOUDNESS
VOLUME VOLUME
MUTE MUTE 1 1 AUX/DVD AUX/DVD 2 2 RECORDER RECORDER CD CD PHONO PHONO TUNER TUNER
INPUT SELECTOR INPUT SELECTOR
INTEGRATED AMPLIFIER PM5003 INTEGRATED AMPLIFIER PM5003
L L R R
BASS BASS
POWER ON/OFF POWER ON/OFF
TREBLE TREBLE BALANCE BALANCE STANDBY STANDBY
B B SOURCE DIRECT SOURCE DIRECT A A SPEAKERS SPEAKERS
q w r y e t u
i o !3 !0 !1 !2
q POWER SWITCH
Pressing once switches the power ON, and
pressing again switches it OFF.
If the POWER switch is in the ON position,
the power of this unit can be turned ON/OFF
by pressing the POWER button on the remote
controller.
w STANDBY INDICATOR
Lights up when the unit is in the standby mode.
e INPUT SELECTOR
Selects the program source to be recorded or
played from the PHONO, TUNER, CD, AUX/
DVD, RECORDER 1 (CD-R), and RECORDER
2 (MD/TAPE).
r SOURCE DIRECT button and
indicator
This button turns SOURCE DIRECT mode ON
and OFF. When SOURCE DIRECT is ON, the
center of the button is lit. In the Source Direct
mode, the audio signals bypass the tone control
circuit.
t FUNCTION INDICATORS
One of the indicators lights up to indicate
the input source selected with the INPUT
SELECTOR.
y MUTE INDICATOR
Light up when the MUTE button in the remote
controller is pressed.
NOTE:
Be sure to check the VOLUME control
setting before pressing this switch to cancel
muting. If the muting is canceled while the
volume setting is high, the speakers could
be damaged.
u VOLUME CONTROL
Adjusts the volume level. Turn the knob clockwise
to increase the volume.
i REMOTE SENSOR
The remote sensor receives the infrared
commands from the remote controller. When
an infrared signal is received from the remote
controller. The remote controller must always be
pointed directly at the remote sensor.
o BALANCE CONTROL
Turn the knob to correct an unbalanced program
source such as stereo broadcast or to vary the
output level of the left or right channel. Note
that, if the BALANCE control is turned fully in
one direction, the sound will not be heard from
the speaker on the other side.
!0 LOUDNESS button and indicator
This button turns LOUDNESS ON and OFF.
When LOUDNESS is ON, the center of the
button is lit. The LOUDNESS cmpensates for
human hearing characteristics by boosting the
bass and treble response at low volume levels
to achieve a more pleasing tonal balance.
!1 SPEAKERS A/B buttons and
indicators
These buttons turn the speaker output to
the speakers connected to the SPEAKER
SYSTEMS A/B terminals on the rear panel
ON and OFF. When speaker output is ON,
the center of the button is lit. To listen with
headphones, turn speaker output OFF.
!2 BASS AND TREBLE TONE
CONTROLS
Adjusts the tone by controlling the levels of two
frequency bands. Turn each control toward (+)
to enhance the corresponding frequency band,
or toward (–) to attenuate it.
TREBLE: Adjusts the high frequency level.
BASS:
Adjusts the low frequency level.
!3 PHONES JACK
Insert the standard phone plug of the
headphones into this jack.