Marantz PM5003 - Manual (Page 13)

10
BASIC
CONNECTIONS
BASIC
OPERA
TION
REMOTE CONTROLLER
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND FUNCTIONS
ADV
ANCED
CONNECTION
ENGLISH
ADVANCED CONNECTION
R
OUT IN OUT IN
L
R
L
R L
R L
R
L
PHONO TUNER CD AUX / DVD RECORDER 2
(MD / TAPE)
RECORDER 1
(CD-R)
SPEAKER SYSTEMS SPEAKER SYSTEMS
REMOTE REMOTE
CONTROL CONTROL
FLASHER FLASHER
IN IN
SYSTEM B SYSTEM B
CLASS 2 WIRING CLASS 2 WIRING
SYSTEM A SYSTEM A
AC OUTLETS AC OUTLETS
120V 60Hz 120V 60Hz
UNSWITCHED UNSWITCHED
120W 1A MAX 120W 1A MAX
SWITCHED SWITCHED
120W 1A MAX 120W 1A MAX
IN IN
OUT OUT
AC IN AC IN
PHONO
GND
+ -
REMOTE CONTROL
IN OUT
RC OUT
EXTERNAL INTERNAL
q w
CD player
OPTION
OUTPUT INPUT
CONNECTING THE REMOTE CONTROL JACKS
7
Remote control settings
SPEAKERS A/B button
PHONES PHONES
MIN MIN MAX MAX
LOUDNESS LOUDNESS VOLUME VOLUME
MUTE MUTE 1 1 AUX/DVD AUX/DVD 2 2 RECORDER RECORDER CD CD PHONO PHONO TUNER TUNER
INPUT SELECTOR INPUT SELECTOR
INTEGRATED AMPLIFIER PM5003 INTEGRATED AMPLIFIER PM5003
L L R R
BASS BASS
POWER ON/OFF POWER ON/OFF
TREBLE TREBLE BALANCE BALANCE STANDBY STANDBY
B B SOURCE DIRECT SOURCE DIRECT A A SPEAKERS SPEAKERS
q
You can control other Marantz products through this
unit with the remote controller by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote controller
is received by the remote sensor on this unit. Then
the signal is sent to the connected device through
this terminal. Therefore you need to aim the remote
signal only to the unit.
Set the REMOTE CONTROL SWITCH on the back of
other units (not the PM5003) to “EXT”.(EXTERNAL)
to use this feature.
w
Whenever external infrared sensors or similar
devices are connected to Remote Control IN of
the unit, be sure to always disable operation of the
infrared sensor on the unit by using the following
procedure.
1. Press and hold the SPEAKER B button on the
front panel more than 5 seconds.
2. Front remote sensor is disabled and MUTE
indicator blink 3 times.
NOTES:
• Be sure to set remote sensor enable when
external infrared sensors or similar devises are
not connected.
• Otherwise the unit will be unable to receive
remote control commands.
3. To restore the original setting, press and hold
SPEAKER A button on the front panel more
than 5 seconds.
4. Front remote sensor is enabled and RECORDER
2 indicator blink 3 times.