Marantz PM5003 - Manual (Page 15)

12
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTION
REMOTE CONTROLLER
OPERA
TION
OTHERS
NAMES AND FUNCTIONS
TROUBLESHOOTING
ENGLISH
TROUBLESHOOTING
In case of trouble or abnormal operation of the unit, check the following before contacting service personnel.
What may seem to be a serious malfunction is often the result of a simple operation mistake. If the trouble
persists after checking the following, please contact your dealer or nearest Marantz distributor.
* The amplifi er does not operate and the
indicators do not light.
1. Check to see if the power cable is inserted
properly into the power outlet.
* The indicators light but the amplifi er does
not operate.
1. Check to see if the SELECTOR, SPEAKER
switches and VOLUME control are properly
set.
* Sound is heard from only one of the
speakers.
1. Check to see if the BALANCE control is
properly set.
2. Switch the power of the unit to OFF, and change
the connections of the left and right speaker
cords. If the sound from the same speaker is still
not heard, its connection cord or the speaker
itself may be defective.
* Considerable hum noise is heard when
the turntable is played.
1. Check to see if the plugs from the turntable are
properly connected to the PHONO jacks.
2. Connect the grounding wire of the turntable to
the GND terminal on the rear panel of this unit.
If it has already been connected, try removing
it.
3. Check to make sure that the phono cartridge is
attached securely to the tonearm.
4. Unplug the power cable and plug it in again after
inverting the orientation of the blades.
* Remote control operation is not possible.
1. Is the remote controller's transmitter pointed
correctly at the remote sensor on the front of the
Amplifier?
Or, is there an obstruction between the
transmitter and the remote sensor?
2. Are the batteries in the remote controller
exhausted?
3. Is there another strong light (from a window,
etc.) striking the Amplifier remote sensor?
4. Is an RCA cord connected to the “REMOTE
CONTROL OUT” jack on the Amplifier rear
panel?
5. Is the remote control code different between the
main unit and remote controller?
6. Is the main unit remote sensor disabled?
REMOTE CONTROLLER OPERATION
REMOTE CONTROL CODE
SETTING
x
z
c
The remote control unit contains 3 sets of remote
control codes, and it can be used to control up to
3 amplifiers in one location. To control a second
or third amplifier, select the remote control code
as explained below. The selected amplifier can be
operated from the remote control.
• When the unit is shipped from the factory, the
main unit and remote control are set to AMP1.
1. AMP2
To set the remote control to AMP2, hold down
both the AMP button
z and 2 number button x
on the remote control for at least five seconds.
AMP3
To set the remote control to AMP3, hold down
both the AMP button
z and 3 number button x
on the remote control for at least five seconds.
2. Also set the main unit's remote control setting to
the same setting as the remote control.
3. To change main unit's remote control setting,
hold down the AMP button z and press the
DISPLAY button c on the remote control;
the remote control setting will be indicated by
function indicators on the main unit and main
unit setting will be changed same setting as
remote control.
AMP1 : PHONO indicator blink 3 times.
AMP2 : TUNER indicator blink 3 times.
AMP3 : CD indicator blink 3 times.
NOTES:
• If the main unit is unplugged the mains cord, the
remote control setting will revert to AMP1.
• To set the remote control back to AMP1, hold
down both the AMP button z and 1 number
button x on the remote control for at least five
seconds.