Marantz SR5010 - Manual (Page 188)

Hide Sources
Remove from the display input sources that are not used.
Show
(Default):
Use this source.
Hide: Do not use this source.
Source Level
This function corrects the playback level of the selected input source’s
audio input.
Make this setting if there are differences in the input volume levels
between the different sources.
-12 dB – +12 dB (Default : 0 dB)
0 “Source Level” settings are stored for each input source.
Input Select
Set the audio input mode and decode mode of each input source.
The input modes available for selection may vary depending on the input
source.
0 “Input Select” settings are stored for each input source.
o Input Mode
Set the audio input modes for the different input sources.
It is normally recommended to set the audio input mode to “Auto”.
Auto
(Default):
Automatically detect input signal and
perform playback.
HDMI: Play only signals from HDMI input.
Digital: Play only signals from digital audio input.
Analog: Play only signals from analog audio input.
7.1CH IN:
Only signals input from the 7.1CH IN
connector will be played back.
0 If “HDMI Control” is set to “On” and a TV compatible with the ARC is
connected via the HDMI MONITOR 1 connectors, the input mode whose input
source is “TV Audio” is fixed to ARC.
0 The sound mode cannot be set if the input mode is set to “7.1CH IN”.
Contents Connections Playback Settings Tips Appendix
188
Front panel Display Rear panel Remote Index