7 specifications – Lynx Studio Hilo Reference A/D D/A Converter System - Owner's Manual with LT-USB User Manual
Page 61

Page 57
Q. I am using a mono input into the Line In of Hilo. I have the Line In assigned to my Monitors and Phones Output but
I am only hearing it one side (the side it is connected to). Why?
A. To monitor a mono input signal in the center of the stereo field, go to the Output Mix Routing Page and select the
Input you would like to monitor (make sure the white box is around the Input so that it is “focused” or selected). Under
the Input Meters is the MONITOR MODE select button. Tap that button to launch the menu of options. If your signal
source is plugged into the Left Input of the selected source, then select “Left”. If it is plugged into the Right Input,
Select “Right”. On the OUTPUT METERS you should now see your signal on the both the left and right sides. Note:
The MONITOR MODE selection is active PER INPUT and PER OUTPUT. While this makes the feature very flexible,
keep in mind you may need to select the correct mode for multiple outputs (such as MONITOR OUT and PHONES).
7 Specifications
Line In L/R
THD+N
-114 dB @1kHz, -1dBFS, 20kHz filter, +22dBu trim
Dynamic Range
121 dB, A-weighted, -60dBFS signal method
Frequency Response
± 0.01 dB, 20 – 20kHz
Crosstalk
140 dB maximum @ 1kHz, -1dBFS signal
Full-scale trim settings:
+ 0dBV, +2dBV, +4dBV, +6dBV, +18dBu, +20dBu, +22dBu, +24dBu
Female XLR connectors
Line Out L/R
THD+N
-109 dB @1kHz, -1dBFS, 20kHz filter, +22dbu trim
Dynamic Range
121 dB, A- weighted, -60dBFS signal method
Frequency Response
± 0.02 dB, 20 – 20kHz
Crosstalk
-135 dB maximum @ 1kHz, -1dBFS signal
Full-scale trim settings
+ 0dBV, +2dBV, +4dBV, +6dBV, +18dBu, +20dBu, +22dBu, +24dBu
Male XLR connectors
Monitor Out L/R
THD+N
-107 dB @1kHz, -1dBFS, 20kHz filter, volume at max
Dynamic Range
121 dB, A- weighted, -60dBFS signal method
Frequency Response
± 0.02 dB, 20 – 20kHz
Crosstalk
-135 dB maximum @ 1kHz, -1dBFS signal
Output level at max volume
+24dBu or +10dBu, jumper selectable
TRS
connectors
Headphone Out
THD+N
-107 dB @1kHz, -1dBFS, 20kHz filter, volume at max
Dynamic Range
121 dB, A- weighted, -60dBFS signal method
Frequency Response
± 0.02 dB, 20 – 20kHz
Crosstalk
-130 dB maximum @ 1kHz, -1dBFS signal
Output level at max volume
+19dBu
¼” phone jack on front panel
Digital I/O
AES/EBU
Transformer-coupled on XLR connectors
S/PDIF
I/O
coax
Transformer-coupled on RCA jacks