Lynx Studio LynxONE - Manual (Page 6)

Page 6
Windows 95/98/98SE® Installation
The procedure for installing the LynxONE in Windows 95/98/98SE requires that the
LynxONE Setup Program be run before you install your LynxONE inside your computer.
This program will install the required driver files needed for the Windows Plug-and-
Play configuration manager to recognize the LynxONE as a new device and will install
the LynxONE Mixer application.
Running Setup
1. With your computer running Windows 95 or Windows 98, insert the 3½” floppy
supplied with your LynxONE into your computer’s floppy disk drive.
2. Select “Start” from your system menu, then “Run…”.
3. Type A:\SETUP.EXE into the Run window and select the OK button.
4. The “LynxONE Windows 95 Driver Installation Wizard” will appear.
5. After reading the instructions on the screen, press “Continue”.
6. The Driver Installation Wizard will copy all of the files needed to the appropriate
directories.
7. When the “Installation Complete” message appears, read the instructions on the
screen, then press “Shutdown”.
Installing the LynxONE
1. Turn OFF the power to your computer system and disconnect the power cords.
2. Touch a metal plate on your computer system to ground yourself and discharge
any static electricity.
3. Remove the cover from your computer system case. You should refer to your
computer system documentation for any special instructions on installing expansion
cards and peripheral equipment.
4. Find an empty PCI slot in your computer.
5. Unscrew and remove the slot cover from your selected PCI slot.
6. Remove your LynxONE from its static bag and gently insert it into the selected
PCI slot. Press it down firmly so that the contacts are securely seated in the slot.
7. Secure the LynxONE card with the screw removed from the slot cover.
8. Replace the computer system case and plug in your computer.
9. Connect the Audio and MIDI/Clock cables to the LynxONE. See the External
Connections section for more information.
Restarting Your Computer
1. Turn on your computer and start Windows 95 or Windows 98.
2. After the Windows logo splash screen is complete, the Plug-and-Play configuration
manager will display a “Found New Hardware” message.
3. Windows will ask where the driver is located. You should enter:
C:\Windows\System
Then click on “OK”.
4. Depending on your hardware setup, Windows may need to restart before
proceeding.
5. Please read the “Release Notes” in the startup menu “Lynx Studio Technology”
group.
Installation