Step 2, ribbon threading – Luxi Electronics DIY-30BS10 User Manual
Page 5
Website:
www.luxielectronics.com
Email:
Phone: +1 (949) 654-2047
Address: Irvine, CA, USA
HD DIY user manual ribbon wires
Revision: 2.00
Date: 1/26/2015
US patents: 8002572, 8500489, 8507796 issued; others issued or pending in multiple countries
Step 2, ribbon threading
2.1 First identify the embossed arrow on the
outer side of each wire holder
2.2 Slide top ribbon in the direction of the arrow
with the red stripe line up with the arrow side
2.3 Do the same with the bottom ribbon
2.4
Important!
Slide wire holders as far as they can go
for best performance
2.5 Insert one wire holder all the way into No. 1 hole of
the hand tool following the marked orientation and
perform a pre-crimp; repeat for the other one
2.6 During the pre-crimp a recessed blade would cuts
off the wires and a tiny slice of the wire holder; this
is normal