LSC Lighting e24V3 - Manual (Page 13)

e24 Dimming System E24V3 QUICK TOUR
Operator Manual V3.0
LSC Lighting Systems (Aust) Pty. Ltd Page 9
3.4 Rear Panel
e24V3 Australian model Rear View
The e24V3 is available in many configurations of
input, patch bay and output connections.
3.5 Input Power
Australian models have 3 options for input
power;
• Two 2m cables, each fitted with a
Clipsal style 32A 5-pin three phase plug.
• Two 2m cables, each fitted with a
Clipsal style 40A 5-pin three phase plug.
• One set of 5 x 400A Powerlocks.
Export (non Australian) models have 3 options
for input power;
• One 63A 5 pin CEEform connector.
• One 125A 5 pin CEEform connector.
• One set of 5 x 400A Powerlocks.
Export model CEEform input connector
3.6 Patch Bay Options
Note: The e24V3 also has a DMX Softpatch
allowing any of the 24 dimmer channels to be
patched to any DMX slot number. See
section 6.3.1 Patching.
Australian models use GST18 patch bay
connectors. The channel outputs are available in
two optional configurations:
• Two parallel (230 Volts) dimmer outputs
and a dimmer output wired in series to
two connectors (allowing two 115 Volt
loads to be connected in series across
230 volts) plus two Hot-power outputs
per channel.
• Four parallel dimmer outputs plus two
Hot-power outputs per channel.
Captive Patch
Leads
(internally wired
to Output
Connectors).
Dimmer and
Hot Power
Patch Bay
Three phase
power input tails
fitted with
32A 5-pin plugs
(Other options
available)
Auxiliary Output
connectors
Output
Connectors.
Patch Cable
and Output
Connector
panel.