Denon DN-M991R - Manual (Page 18)

18
ENGLISH
BASIC OPERATION
(1) Starting Playback
1
2
Make the presettings according to the usage purpose.
(See Page 13.)
NOTE: Steps 1, 2 and 3 can be performed in the opposite
order.
3
4- 1
Select the play mode.
Turn the PLAY MODE switch.
Load the cartridge.
Single track play mode
Continuous play mode
Select the track to be played.
Turn the select knob.
The selected track is cued and the standby mode is set.
Flashing during search Lit when in standby
1
To check the play end position.
Press the END MON button when in the standby mode.
The track’s end is monitored, then the pickup returns to
the play start position and the standby mode is set. (End
Monitor)
NOTE: If the STANDBY/CUE button is pressed during the
end monitor operation, the end monitor operation
is canceled, the pickup returns to the play start
position and the standby mode is set.
(2) End Monitor
6- 2
Playback can be stopped in the following ways:
Playback is interrupted, the pickup returns
to the play start position and the standby
mode is set. (BACK CUE)
Lit
Lit
Flashing (orange)
Lit
Playback is interrupted and the
pause mode is set at that point.
Flashing
4- 2
Starting playback from the middle of track.
• To start from the middle of a track, use the SEARCH
buttons to move to the desired position.
• Press one of the SEARCH buttons ( 6 or 7 ) in the
play, pause or standby mode to set the search mode.
• Press the 7 SEARCH button to move forward, the
6 SEARCH button to move backward.
To move forward To move backward
5
Start playback.
Press the PLAY/PAUSE button.
Lit (green) Off
6- 1
Presetting the next track to be played during playback.
• The track at which the standby mode is to be set or the
track to be played next after the current track is played
can be preset by turning the SELECT knob during
playback.
In the single mode, the standby mode is set at the
beginning of the next track.
In the continuous mode, the next track is played
when playback of the current track finishes.
• The Next Track display of the set track number flashes.
Flashing
Example: When track 7 is selected while playing track 1
5
Playback begins and the playback signals are output.