Dimplex DF3215 - Manual (Page 12)

LIGHT DIMMER
1. Press the Flame/Heat button to turn the Flame/Heat ON.
2. Press the ENTER button, the middle display flashes.
3. Use the direction buttons on the hand held remote to move the cursor to and press
ENTER.
4. Repeatedly press the left or right direction button to decrease or increase the
brightness of the upper lights.
NOTE
The bar graph located on the top of the display screen indicates the upper light brightness
range.
AMBIENT LIGHT SENSOR
When the room gets darker the upper lights dim, allowing for a more desirable and realistic
flame effect. The ambient light sensor is located in the bottom of the remote. (FIGURE 6)
1. Press the Flame/Heat button to turn the Flame/Heat ON.
2. Press the ENTER button, the middle display flashes.
3. Use the direction buttons on the hand held remote to move the cursor to and press
ENTER.
4. Press the up direction button to turn the ambient light sensor ON, press the down
direction button to turn the ambient light sensor OFF.
5. Press ENTER to return to the main menu.
SLOW START/FADING EMBERS
The slow start function simulates a starting fire. The slow start function timer is automatically
programmed for 30 seconds. The slow start timer setting cannot be changed. The fading
embers function simulates a fire going out. The fading embers function timer can be set to 1,
5, or 10 minutes.
1. Press the ENTER button, the middle display flashes.
2. Use the direction buttons on the hand held remote to move the cursor to and press
ENTER.
3. Press the left or right direction button to select 1, 5, or 10 minutes for the fading
embers.
4. Press the up direction button to turn the slow start/fading embers function ON, press
the down direction button to turn the slow start/fading embers function OFF.
5. Press ENTER to return to the main menu.
6. Press the Flame/Heat on/off button to activate the slow start/fading embers.
NOTE
When turning the unit OFF with the slow start/fading ember function ON, the slow
start/fading ember indicator will flash for 1 minute.
OCCUPANCY SENSOR
The occupancy sensor function can be programmed to turn the fireplace ON when it detects
movement. The occupancy sensor is programmed to turn the fireplace OFF when it doesn’t
detect movement in 5, 10, or 20 minutes. The occupancy sensor is located in the bottom of
the remote. (FIGURE 6) The occupancy sensor has a range of 10 feet.
1. Press the ENTER button, the middle display flashes.
2. Use the direction buttons on the hand held remote to move the cursor to and press
ENTER.
3. Press the left or right direction button to 5, 10, or 20 minutes.
4. Press the up direction button to turn the occupancy sensor ON, press the down
direction button to turn the occupancy sensor OFF.
5. Press ENTER to return to the main menu.
10