La Crosse Technology WS-9724 - Manual (Page 5)

54
girl" icon will be displayed. If these are not displayed after 60 seconds, remove the
batteries and wait for at least 10 seconds before reinserting them.
3. After inserting the batteries, the Weather station will start receiving data from the
transmitter. The outdoor temperature & humidity and the signal reception icon should
then be displayed on the Weather station. If this does not happen after 3 minutes, the
batteries will need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, this should under good
conditions be a distance no more than 100 meters between the final position of the
Weather Station and the transmitter (see notes on “Mounting” and “868 MHz
Reception”).
5. Once the remote temperature has been received and displayed on the Weather station,
the DCF time (radio controlled time) code reception is automatically started. This takes
typically between 3-5 minutes in good conditions. If after 10 minutes, the DCF time has
not been received, press the SET key to manually enter a time initially.
When more than one transmitter is used
1.
User shall remove all the batteries from the weather station and transmitters and wait for
60 seconds if setting has been done with one transmitter before.
2. Insert the batteries to the first transmitter.
3. Within 25 seconds of powering up the first transmitter, insert the batteries to the Weather
Station. Once the batteries are in place, all segments of the LCD will light up briefly.
Following time as 0:00 and the weather girl icon will be displayed. If they are not shown in