D-Link DI-713P - Manual (Page 52)

52
The following screen will be shown:
Firmware Version = 2.51 build 9
Command List:
IP (set device IP; e.g. IP 192.168.123.254)
PW (set new PassWord; e.g. PW admin)
DS (toggle Dhcp Server setting)
SR (Save new setting and Reboot)
RR (Restore default setting and Reboot)
Current Setting:
Device IP = 192.168.0.1
DHCP Server = Enable
>
If the command list screen doesn’t show, start this step over again and
watch the LED’s on the Broadband Router closely so that you press the
ENTER key at the correct time.
5. The command list shows the commands that you can use. The Current
Settings portion shows the current configuration. Type the command
and press the ENTER key to execute that command. For example: if
you wanted to change the IP address and the Password from the current
setting to IP address “192.168.200.210” and the password to “john”,
you would type the following:
IP 192.168.200.210 (hit ENTER)
PW john
(hit ENTER)
And then to save the settings and restart the Broadband Router, type SR
and hit ENTER.