Kreg Jig HD - Manual (Page 10)

www.kregtool.com 800-447-8638
Additional Components Additional Components For more detailed instructions, please
visit us online at www.kregtool.com.
Kreg Jig ® HD Driver Bit
(Item no. D6HD)
Replacement 6”-long #3 square drive bit.
For best results, center the Face Clamp™
pads on the joint line. To keep the workpieces
perfectly fl ush, make sure the large clamp
pad is on the face side of the joint (opposite
the pocket-holes). Clamp fi rmly to reduce the
possibility of workpiece movement.
Face Clamp TM
Perfectly fl ush Kreg Joints TM , in no time.
Kreg Jig ® Base
The Kreg Jig ® HD is compatible with the
Kreg Jig ® and Kreg Jig ® ® Master System ®
bases. Simply remove the Stop Block from
the Kreg Jig
® HD Drill Guide, slide it into the
base, and secure it with the drill-guide pin.
Now you’re ready for convenient bench-
top production drilling. The Dust collection
attachment in the Master System helps
you keep a clean shop, and by effi ciently
removing chips, enables faster drilling and
extends the life of your drill bit.
Replacement drill bit, stop collar, and hex
wrench.
Kreg Jig ® HD Screws
30-count screws
(Item# SML-C2X250-30)
125-count screws
(Item# SML-C2X250-125)
Kreg Jig ® HD Drill Bit
(Item no. KJDHD)