Assembly – Delta SS350LS User Manual

Page 9

STAND

NOTE: THE ASSEMBLY OF THIS STAND WILL USE

M8X16MM CARRIAgE HEAD SCREWS AND M8 FLANgED

HEX NUTS. kEEP THE HEAD OF THE CARRIAgE HEAD

SCREWS TO THE OUTSIDE OF THE STAND WITH THE

FLANgED HEX NUTS TO THE INSIDE OF THE STAND.
NOTE: MAkE SURE THAT THE SHELF ON THE BRACES

ARE ON TOP WHEN ATTACHINg THE BRACES TO THE

LEgS.
Assemble stand as shown in Fig. 2 using parts shown in Fig.

1. The braces, legs and feet are labeled the same in both

illustrations. Insert the M8x1.25x16mm carriage head screws

through legs and braces then secure with the M8x1.25 flange

hex nuts. Loosely tighten hardware at this time.
NOTE: MAkE SURE THAT THE DIMPLES ON THE LEgS

(A) FIg. 2 ARE ENgAgED WITH THE HOLES ON THE

BRACES (B). Fig. 2

SCROLL SAW TO STAND

1. Place the scroll saw on the top braces of the stand Fig. 3.
2. Align the three holes (A) Fig. 3, (two of which are shown),

with the three holes in the top of the stand.

3. Place a 5/16" flat washer on a 5/16-18x1½" hex head

screw, insert the screw through the hole in the base of

the scroll saw and the hole in the stand. Place a 5/16" flat

washer, 5/16" lockwasher and thread a 5/16-18 hex nut

onto the screw. Repeat this process for the two remaining

holes in the scroll saw base and stand.

4. Tighten all stand hardware securely.

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is

completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

1/2" and 13mm wrenches (not supplied)

ASSEMBLY TIME ESTIMATE

Assembly takes approximately 30 minutes to 1 hour.

Fig. 2

Fig. 3