Delta SS350LS User Manual

Page 12

TILTINg THE TABLE

Disconnect machine from power source.

The table on your scroll saw can be tilted 45° to the left for

bevel cutting operations by removing the dust cup as shown

in Fig. 24 and loosening table lock knob (A) Fig. 10, tilt the

table to the desired angle indicated on degree scale (B) Fig.

11 and tighten lock handle (A) Fig. 10.
When bevel cutting, the holddown (B) Fig. 12, can be

adjusted to lay flat on the stock by loosening screw (C) and

tilting the holddown (B). Then tighten screw (C).

ADJUSTINg THE TABLE

Disconnect machine from power source.

1. Loosen table lock knob as shown in Fig. 10 and move

the table all the way to the right until angle indicator

shown in Fig. 11 is on "0".

2. Using a square that includes a level, check to see if the

table is level (A) Fig. 13, and is 90° to the saw blade (B),

as shown.

3. If the table is not at 90° to the blade, adjust the table

making certain screw (B) Fig. 14, contacts bottom of

table surface when table is 90° to the blade. To make

this adjustment loosen nut (C), turn screw (B) in or out

the desired distance and tighten nut (C).

NOTE: After adjusting table, reposition the pointer (B) Fig.

11 to "0" degrees. Loosen the screw (A) Fig. 11 and adjust

pointer (B) to "0" degree mark and retighten screw (A).

Fig. 10

Fig. 11

Fig. 12

Fig. 14

Fig. 13