Standard Horizon HX-471S - Manual (Page 41)

HX471S Page 39
12. CLONING
The HX471S includes a convenient “Clone” feature, which allows the memory
and configuration data from one transceiver to be transferred to another
HX471S.
Turn both radios off.
1. Connect the (optional) CT-32 Clone Cable between the MIC/SP jacks of
the two transceivers.
2. Hold down the [PRESET] key and then turn on the transceiver. Do this
for both transceivers (the order of switching the radios on does not mat-
ter); “CLONE” will appear on the display on both transceivers.
3. On the Destination transceiver, press the [MEM] key (“
CLONE RX” will
appear on the LCD).
4. Press the [16/9] key on the Source transceiver; “
CLONE TX” will appear
on the Source radio, and the data will now be transferred.
5. If there is a problem during the cloning process, “ CLONE ERR” is dis-
played. Check your cable connections and battery voltage, and try again.
6. If the data transfer is successful, the Destination transceiver will return
to normal operation; Turn both transceivers off and disconnect the Clone
cable. You can then turn the transceivers back on, and begin normal
operation.