Resetting the transceiver’s microprocessor – Standard Horizon HX-471S User Manual
Page 40
HX471S
Page 38
11. RESETTING THE TRANSCEIVER’S MICROPROCESSOR
Resetting the microprocessor restores the initial, factory-supplied conditions
in the transceiver. These are called the “default” conditions.
To reset the microprocessor, first turn the transceiver off. Then, while press-
ing and holding in the [WX] and [SCAN] keys, turn the transceiver on.
The default conditions are:
• No channel numbers are in scan memory.
• Channel 16 is the priority channel.
• Channel 16 will be selected when the transceiver is turned on.
• WX channel 01 will be recalled when the [WX] key is pressed.
• Preset Channels are unassigned.
Note: The above procedure also resets the microprocessor. Perform this
procedure if an operational problem occurs which cannot be solved by nor-
mal operating procedures.