beautypg.com

Warning, Removing handles tools required, Connecting water supply – Kleenmaid V Series User Manual

Page 4: Stabilize refrigerator and align doors

background image

4

Removing Handles

Tools Required

Putty knife (blade covered by masking tape)
8 mm hex nut driver
9.5 mm hex nut driver
Phillips screwdriver
Blade screwdriver

WARNING

Disconnect power to refrigerator before removing doors
to avoid electrical shock which can cause severe
personal injury or death. After replacing doors, connect
power.

Some installations may require handle removal to get the
refrigerator into the home. If so, perform the following
steps:

• Pry up edge of handle trim using a putty knife, with the

blade end covered in masking tape. Remove handle
from door by removing 2 mounting screws at each end
of handle.

A

C

B

A

A.

Handle trim

B.

Handle screws

C.

Handles

Handle removal

• Reverse procedure to replace handle.

Models with full length extruded handles
• Remove top trim with phillips screwdriver (some

models). Remove handle cap.

• Lift handle up until it hits stop, pull handle away from

door. Clips on door slide out of notches on back of
handle.

B

A

C

A.

Top trim

B.

Handle clip

C.

Handle

Handle removal

• Reverse procedure to replace handle.

Connecting Water Supply

Connection of water supply is to be completed by a
qualified engineer.

Stabilize refrigerator and align doors

If refrigerator rocks or is not stable on floor perform
the following:
• Determine which rear corner is rocking.
• Remove toe grille to gain access to roller

adjustment screws.