Kleenmaid V Series - Manual (Page 12)

12
• Remove baskets by pulling out and lifting. Replace
baskets by placing baskets on side rails, slide baskets
right and back until round knob is behind stop on rail.
• Remove shelf by lifting right side of shelf out of clips
and pulling out of left side mounting holes. Reverse
procedure to reinstall shelf.
A
B
A. Wire shelves B. Wire baskets
Freezer baskets and shelf
Ice ‘N’ Water ™ Dispenser
(some models)
Caution
To avoid personal injury or property damage, observe
following instructions:
• Do not operate dispenser with freezer door open.
• Do not put fingers, hands, or any foreign object into
dispenser opening.
• Do not use sharp objects to break ice.
Water Dispenser Operation
It takes approximately 1 minute after pressing dispenser
bar the first time before water dispenses after initial
connection of water supply. Discard first 10 to 14
containers of water after first connecting refrigerator to
household water supply and after extended periods of
nonuse.
• Dispense water by pressing glass or cup against water
dispenser bar.
• Stop water dispensing by releasing pressure on bar. A
small amount of water may continue to fall. Spill shelf
is not self-draining. Large spills should be wiped dry.
Ice Dispenser Operation
Caution
To avoid property damage, do not dispense ice directly
into thin glass, fine china, or delicate crystal.
• Select cubed or crushed mode by sliding lever on
dispenser panel. Dispense ice by pressing glass or cup
against ice dispenser bar.
Important
Reduce spraying of crushed ice by holding glass or
cup directly under ice chute and as high as possible
in dispenser area.
CUBED CRUSHED
ICE
Cup placement in dispenser
• Stop ice dispensing by releasing pressure on bar
before container is full. Some ice will continue to fall.
Do not remove container until last of ice falls.
If dispensing ice continuously, dispenser motor is
designed to shut off after 3 to 5 minutes. Motor resets
after 3 minutes and dispensing can continue.
A slight delay occurs when switching between cubed and
crushed modes. Pieces of crushed ice will vary in size
and shape. "Snow" may form on door and ice chute when
repeatedly dispensing crushed ice. Allow "snow" to
evaporate or wipe dry.
Dispenser operates only with cubes of proper size and
crescent shape. Do not add purchased ice cubes or other
shaped cubes to ice bucket.
Removing Ice Bucket
• Remove ice bucket by lifting bucket and pulling out.
• Replace ice bucket by sliding in until bucket locks in
place. Ice bucket must be locked in place for proper
ice dispensing. If freezer door does not close, bucket is
not in proper location.