Kleenmaid TO900X - Manual (Page 12)

11
Electronic Timer and
Programming the Oven
Interval Time
Duration
Operation End
Roast Probe
Programming + / - Dial
Figure 4
Legend:
hh
hours
mm minutes
ss seconds
Time of day
Setting range: 0.01 ... 24.00 (hh.mm)
• When power is applied, “0.00” the duration
and operation end indicators will
alternately flash in the LED display.
• Time-of-day has to be set before any
function is available.
• Press 1 st and 2 nd button from left, “0.00”.
The indicators will be displayed steadily.
• Simultaneously rotate the programming
+ / - dial until the actual time-of-day is
displayed (setting).
• When releasing the buttons, time-of-day
starts precisely to the second. Duration
and operation end indicators disappear,
the manual indicator flashes to show that
the timer should be switched over to
manual mode.
Minute Minder
Setting range: 0.01 . . . 99.00 (mm.ss)
• Press Interval Time button (1 st from left).
The time display will show “0.00“and the
indicator will illuminate.
• Rotate the Programming + / - Dial until the
desired interval time is set.
• On releasing the button, the run down of
the interval time starts precisely to the
second. The display reverts to time-of-day,
and the indicator is illuminated steadily.
• Once the interval time has elapsed, the
alarm sounds (max. 2min). The indicator
flashes.
• Press any button to stop the alarm. The
indicator will disappear.
Immediate Operation/Automatic Shut-
Off
Setting the Duration
Setting range: 0.01 . . . 23.59 (hh.mm)
• Press duration button (2 nd from left). The
display shows “0.00” and duration
indicator steadily.
• Rotate the Programming + / - Dial until the
desired duration appears in the display.
• Releasing the button starts the run down
of time; time-of-day reappears. The
indicator is illuminated steadily. The
operation starts at once.
• After the preset duration has elapsed, the
alarm sounds (max. 2 min). The duration
indicator will disappear and the operation
end indicator and temperature display will
flash alternately. Stop the alarm by
pressing the operation end button (3
rd
from left) once, press it again to switch the
oven manual mode. The indicators will
disappear.
Setting the Operation End Time
Setting range: 0.01 . . . 23.59 (hh.mm)
• Press the operation end button (3 rd from
left). Display shows “0.00“and the
operation end indicator are illuminated
steadily.
• Rotate the programming + / - dial until the
desired operation end is displayed.