Kleenmaid CH605CE - Manual (Page 4)

Instructions for use, mounting and connection 4
Important warnings
•
The appliance may be built-in and connected to
the power supply only by a qualified technician.
•
Particular areas of the cooktop surface
(adjacent to the hotplates) are hot during
operation. Make sure children are kept out of
reach and warn them accordingly.
•
Hot oil ignites readily, so be sure preparation of
such food (fries) is under constant control.
•
Do not leave an empty pan on a heating zone.
•
Do not use the appliance for room heating.
•
Never use the ceramic-glass cooktop as a
working surface. Sharp objects may damage
the cooktop surface.
•
Do not place saucepan lids on the cooktop
surface. Extreme pressure can build up while
cooling and cause the ceramic top to crack!
•
Never keep any flammable or temperature
sensitive objects, like cleaning agents, sprays,
detergents, etc., below the appliance.
•
Preparation of food in aluminium or plastic
cookware is not allowed. Never place any
plastic objects or aluminium foil upon the
cooktop surface.
•
In case any other appliances are plugged in the
electric mains close to the cooktop, prevent the
contact of the plug cable with the hot cooking
zones.
•
Never use a cracked or broken ceramic-glass
cooktop. If you notice any visible cracks on the
surface, cut the power supply immediately.
•
In case of any malfunctions, disconnect the
appliance from the power supply and call your
nearest authorised Kleenmaid Service Agent on
1300 652 100.
Connection to the power supply
•
Electrical connection must be carried out by a
qualified technician only. The earthing protection
must comply with the standing regulations.
•
Connection terminals are revealed when the
connection box cover is removed.
•
Prior to connection check that the voltage
indicated on the rating plate is in line with your
home power supply.
•
The rating plate is located underneath the
appliance.
•
The appliance is manufactured for use with the
power supply voltage AC 240 V.
•
The electrical wiring should be equipped with a
circuit breaker able to isolate the appliance from
the mains in all points, with the distance between
terminals of at least 3 mm in open position. This
may be done by means of fuses, safety switches,
etc.
•
Electrical connection should be in accordance with
the declared charge capacity of the mains and the
fuse power.
•
The appliance can be mounted on one side next
to a high kitchen cabinet, the height of which may
exceed that of the appliance. On the opposite side
however, only a kitchen cabinet of equal height as
the appliance is allowed.
•
Upon the completion of installation, live wires and
isolated cables must be adequately protected
against accidental touching.
•
Distance between the cooktop surface and the
cooking hood must be such as indicated in the
instructions for use of the hood.
•
Kitchen cabinets may not be mounted underneath
the built-in ceramic-glass cooktop.
Basic adjustment of sensors to the
ambience
Upon each connection to the power supply the
sensors of the appliance are automatically
adjusted to the environment to ensure their
proper function. All displays indicate the sign "-".
Once the successful adjustment is completed it is
signalled with a beep. All displays are switched
off and your cooktop is ready for use.
During the adjustment procedure the sensors
must be free of any objects, otherwise the
adjustment procedure will be interrupted until
such objects are removed from the sensor
surface. During this period the regulation of the
cooktop is impossible.
ATTENTION !
Before attempting any repairs on the appliance,
disconnect the power supply. In accordance with
the mains voltage the appliance should be
connected in line with the attached diagram. The
earthing wire (PE) must be connected to the
terminal marked with the earthing symbol .
The connection cable must lead through the relief
safety device, protecting it from accidental pulling
out.
Upon the completion of installation switch all the
hotplates on for about 3 minutes to check the
proper functioning.
Warning! The appliance is not intended for
use by young children or infirm persons without
supervision.