En 5. maintenance and cleaning, Spare parts, 1 assembling fa pressure conditioner – Kemppi FreshAir Pressure Flow Control unit User Manual

Page 11

MAINTENANCE AND CLEANING

FA Pressure Flow Control unit

Every time you finish work, it is recommended to clean the FA Pressure Flow

Control unit, to check individual parts and to replace the damaged ones.

• Cleaning must be carried out in a well ventilated room. Avoid

inhaling the harmful dust settled on individual parts of the unit and

accessories.

• It is forbidden to use cleaning agents containing solvents or abrasives.

Mild soap detergent and warm water is recommended.

• The air hose can be rinsed with clean water.

• Use a damp cloth for cleaning. Each part must be wiped dry after

cleaning.

FA Pressure Conditioner

• Once a week, drain the condensate from the bottom of the unit, using

the drain cock located at the base of the unit. Before completing

this operation, it is recommended to disconnect the unit from the

compressed air supply.

• Replace the filter at least once every three months. After this period,

viruses and bacteria may proliferate in the units filter and if it is used

regularly, the absorption capacity of the activated carbon to eliminate

odour may be exhausted. If the air leaving FA Pressure Conditioner

smells in any way, replace the filter immediately. When replacing the

filter, clean the inner part of the container with a dry cloth.

SPARE PARTS

6.1

Assembling FA Pressure Conditioner

Screw the pressure conditioner body onto the stand.